-Copyright (C) 2001-2012 Free Software Foundation, Inc.
+Copyright (C) 2001-2014 Free Software Foundation, Inc.
See the end of the file for license conditions.
This third edition of 2006 Oct 31 updates the previous editions to GNU
Emacs 22.
-The Texinfo source file `emacs-lisp-intro.texi', formats without
-reported error using `pdfeTeXk', Version 3.141592-1.21a-2.2 (Web2C
-7.5.4) and texinfo.tex version 2006-08-26.17 started by `texi2dvi'
-version 4.8, and with `makeinfo' version 4.8.
-
-This directory contains the following Encapsulated PostScript figures:
-
- cons-1.eps, cons-2.eps, cons-2a.eps, cons-3.eps, cons-4.eps, cons-5.eps
- drawers.eps, lambda-1.eps, lambda-2.eps, lambda-3.eps
-
-See the beginning of the `emacs-lisp-intro.texi' file for appropriate
-settings. These figures are not necessary; they are merely nice to
-look at --- without them you get the same figures printed with ASCII
-characters.
-
-Whether and how you print PostScript depends on your site. You not
-only need to set 'print-postscript-figures' before creating the .dvi
-file, but then must convert the .dvi file to .ps with a 'dvips' or
-equivalent command.
-
-On some systems you will see an error message when `psfig.tex' is
-loaded for the last two .eps files:
-
- ! No room for a new \write .
-
-If this happens, try `epsf.tex' instead of `psfig.tex', or try typing
-RET at the error; the formatting may continue successfully.
-
-Or else find the section that says:
-
- @c !!! Clear print-postscript-figures if the computer formatting this
- @c document is too small and cannot handle all the diagrams and figures.
- @c clear print-postscript-figures
-
-and change the file so it reads: @clear print-postscript-figures
-This will prevent TeX from attempting to load the last few .eps files.
-
You will find additional instructions on formatting in the beginning
of the Texinfo file 'emacs-lisp-intro.texi'. Best Wishes!