<section name="Paths">
<option>
- <p><opt>dl-search-path=</opt> The path were to look for dynamic
+ <p><opt>dl-search-path=</opt> The path where to look for dynamic
shared objects (DSOs/plugins). You may specify more than one
path separated by colons. The default path depends on compile
time settings. The <opt>--dl-search-path</opt> command line
</option>
<option>
- <p><opt>log-time=</opt> With each logged messages log the
+ <p><opt>log-time=</opt> With each logged message log the
relative time since startup. Defaults to <opt>no</opt>.</p>
</option>
the default real-time priority level as configured with
<opt>realtime-priority=</opt> fits in this resource limit, if
<opt>realtime-scheduling</opt> is enabled. The JACK client
- libraries require a real-time prority of 9 by default. </p>
+ libraries require a real-time priority of 9 by default.</p>
</option>
<option>
<p><opt>rlimit-rttime</opt> Defaults to 1000000.</p>
<option>
<p><opt>alternate-sample-rate</opt> The alternate sample
frequency. Sinks and sources will use either the
- default-rate-rate value or this alternate value, typically 44.1
+ default-sample-rate value or this alternate value, typically 44.1
or 48kHz. Switching between default and alternate values is
enabled only when the sinks/sources are suspended. This option
is ignored in passthrough mode where the stream rate will be used.
- If set to the same as the default sample rate, this feature is
+ If set to the same value as the default sample rate, this feature is
disabled.</p>
</option>
be subdivided into several fragments. It is possible to change
these buffer metrics for machines with high scheduling
latencies. Not all possible values that may be configured here are
- available in all hardware. The driver will to find the nearest
+ available in all hardware. The driver will find the nearest
setting supported. Modern drivers that support timer-based
scheduling ignore these options.</p>