-0.9.1 (?/??/2015):
+0.9.3 (??/??/2015):
+-------------------
+
+- Under OS X, install.sh can now be run from the recovery system. This may
+ help work around OS X 10.11's problems with System Integrity Protection,
+ since it should be possible to reboot into the recovery system to install
+ rEFInd without disabling SIP for the main installation, even for just one
+ boot.
+
+0.9.2 (9/19/2015):
+------------------
+
+- Added "--keepname" option to install.sh. This option causes install.sh
+ to keep refind_x64.efi named as such rather than rename it as grubx64.efi
+ when using Shim. This option is meaningful only if the --shim option is
+ also used. This option passes the refind_x64.efi filename as an option to
+ Shim, which overrides the default filename of grubx64.efi. A big caveat:
+ Only Shim 0.7 and later supports this feature. (Shim 0.4 also works if a
+ refind_x64.efi is referred to as "\refind_x64.efi" on the command line,
+ but the need for a leading backslash to refer to a file in the same
+ directory as Shim is so confusing and wrong that I cannot in good
+ conscience support it.) I've not seen signed Shim binaries between 0.4
+ and 0.7, so I don't know if any of them might work.
+
+- Implemented a workaround for a bug in Shim 0.8 that prevented
+ authentication of more than one binary. If any filesystem drivers were
+ installed, the first one would be verified, leaving rEFInd unable to
+ launch anything else unless it was signed by a key in the computer's main
+ Secure Boot db list.
+
+0.9.1 (9/13/2015):
------------------
- When rEFInd identifies the root (/) partition via the Freedesktop.org